RBI Err 114 — Too Low Water Flow
Err 114
Too low water flow. Checks: Check water flow into the system (parameter 1062), it must be higher than parameter 3035. Solutions: Increase the water flow into the system Check for any obstruction into the water system The table classifies it as Blocking error (Err).
Applies to
This low-water or pressure protection code is displayed by the IE2 control (Loc lockout and Err blocking error codes on the display) on Infinite Energy² models (IB/IW 199 through IB/IW 1000), as documented in Infinite Energy 2 (IE2) Boiler IOM, doc IE2IBIOM-3 (82-0147-001), sections 15.15-15.16 (IE2IBIOM-3). Codes can differ between controller generations, so always check the manual that matches your unit.
- RBI Infinite Energy²
- RBI Infinite Energy² 199
- RBI Infinite Energy² 399
- RBI Infinite Energy² 500
- RBI Infinite Energy² 750
- RBI Infinite Energy² 1000
Controller: IE2 control (Loc lockout and Err blocking error codes on the display). Source manual: IE2IBIOM-3.
Why a code is not a diagnosis
A water-pressure or low-water code can mean a genuine leak or empty system, a failed expansion tank, a faulty fill valve, or a sensor problem. The appliance does not distinguish these.
Safe things to observe
- Read the pressure gauge and compare it with the normal cold-system pressure your installer set.
- Look for drips or wet spots near the appliance, pipes and the relief-valve discharge.
Do not
- Do not keep re-pressurizing a system that keeps losing water.
- Do not cap a relief-valve discharge pipe.
How professional service helps
- A technician finds and repairs the leak, checks the expansion tank and fill assembly, and verifies the sensor circuit.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Low-water cutoff
A low-water cutoff is the safety device that stops a boiler from firing when there is not enough water inside it.
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for RBI Infinite Energy².
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Infinite Energy 2 (IE2) Boiler IOM, doc IE2IBIOM-3 (82-0147-001), sections 15.15-15.16 · IE2IBIOM-3 · accessed September 9, 2026
Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.