Skip to content
Boilers.caby ROMA Heating & Cooling

Comparison

Navien NPE-150S2 vs NPE-180S2

Verdict in brief

The NPE-150S2 and NPE-180S2 are the two smallest standard (S2) tankless water heaters. The 150S2 fires 18,000 to 120,000 BTU/h at 0.93 UEF with 6.8 GPM at a 35°F rise; the 180S2 fires 10,000 to 150,000 BTU/h at 0.96 UEF with 8.4 GPM, and weighs 68 lb against 62 lb.

Side by side

Published manufacturer figures. Input and output are kept separate; blanks mean the manufacturer did not publish that value.

Comparison of Navien NPE-150S2 and Navien NPE-180S2
SpecificationNavien NPE-150S2Navien NPE-180S2
Input, minimum18 MBH10 MBH
Input, maximum120 MBH150 MBH
Uniform Energy Factor (UEF)0.93 UEF0.96 UEF
Maximum flow rate at 35°F (19.4°C) rise6.8 GPM8.4 GPM
Weight62 lb68 lb

What actually separates them

Both are condensing tankless water heaters in Navien's standard S2 line — no buffer tank or built-in recirculation, unlike the A2 models — and both are DHW-only appliances. The NPE-150S2 is the only 150-size model in the NPE-2 range and prints a 0.93 UEF, while the NPE-180S2 steps up to 0.96 UEF, one of the highest ratings in the family.

The 180S2 also brings a lower minimum fire (10,000 against 18,000 BTU/h) and a higher ceiling (150,000 against 120,000), with 8.4 against 6.8 GPM at a 35°F (19.4°C) rise. In practice that means the 180S2 handles a heavier simultaneous draw and modulates down further in warm months; the 150S2 remains the smallest-capacity option for light demand.

Both share the 17.3 W x 27.4 H x 13.2 D in cabinet, 3/4" NPT water and gas connections, indoor-or-outdoor installation and NG-to-LP field convertibility; the 180S2 is 6 lb heavier (68 against 62 lb). The efficiency and flow differences make the 180S2 the natural step-up unless the demand calculation is clearly within the 150S2's published range.

CurrentSold in Canada
Input
18–120 MBH
Output (max)
—
AFUE
—

The Navien NPE-150S2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 18,000 to 120,000 BTU/h at 0.93 UEF with up to 6.8 GPM at a 35°F rise.

Natural gasPropaneDHW-only (tankless)
CurrentSold in Canada
Input
10–150 MBH
Output (max)
—
AFUE
—

The Navien NPE-180S2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 10,000 to 150,000 BTU/h at 0.96 UEF with up to 8.4 GPM at a 35°F rise.

Natural gasPropaneDHW-only (tankless)

Frequently asked questions

Why does the smaller model have lower efficiency?

The NPE-150S2 prints 0.93 UEF against the NPE-180S2's 0.96. UEF reflects part-load performance, and the 150S2's 18,000 BTU/h minimum fire is higher than the 180S2's 10,000, which matters in the test's low-draw segments.

Is the NPE-150S2 the smallest NPE-2 model?

Yes. The 150S2 is the only 150-size model in the line; the NPE-A2 range starts at the 180A2. All NPE-2 models are DHW-only water heaters.

Which one fits a one-bathroom home?

Either can, depending on the peak-demand calculation and incoming water temperature. The 150S2 publishes 6.8 GPM and the 180S2 8.4 GPM at a 35°F rise; a licensed contractor should confirm the sizing.

Not sure which one fits your home?

A consultation includes a heat-loss review so the size is right the first time.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate