Skip to content
Boilers.caby ROMA Heating & Cooling

Comparison

Navien NPE-180A2 vs NPE-210A2

Verdict in brief

The NPE-180A2 and NPE-210A2 are adjacent ComfortFlow tankless water heaters, both 0.95 UEF. The 210A2 raises input from 150,000 to 180,000 BTU/h and flow at a 35°F rise from 8.4 to 10.1 GPM, and weighs 77 lb against the 180A2's 73 lb.

Side by side

Published manufacturer figures. Input and output are kept separate; blanks mean the manufacturer did not publish that value.

Comparison of Navien NPE-180A2 and Navien NPE-210A2
SpecificationNavien NPE-180A2Navien NPE-210A2
Input, minimum10 MBH12 MBH
Input, maximum150 MBH180 MBH
Uniform Energy Factor (UEF)0.95 UEF0.95 UEF
Maximum flow rate at 35°F (19.4°C) rise8.4 GPM10.1 GPM
Weight73 lb77 lb

What actually separates them

Both models are condensing tankless water heaters with Navien's ComfortFlow buffer tank and recirculation pump, rated 0.95 UEF on natural gas or propane. They are DHW appliances: neither has a space-heating circuit, so the comparison is about hot-water capacity, not building load.

The NPE-180A2 fires 10,000 to 150,000 BTU/h and publishes 8.4 GPM at a 35°F (19.4°C) rise; the NPE-210A2 fires 12,000 to 180,000 BTU/h and publishes 10.1 GPM. The higher minimum on the 210A2 is immaterial in practice — both modulate far below any single-fixture draw — while the extra 30,000 BTU/h of ceiling is what supports two simultaneous hot-water uses in colder months.

Both share the 17.3 W x 27.4 H x 13.2 D in cabinet, 3/4" NPT water and gas connections and indoor-or-outdoor installation. The 210A2 is 4 lb heavier. Choosing between them follows the peak hot-water demand calculation: if the household's simultaneous draw fits inside 8.4 GPM at a 35°F rise, the 180A2 is the smaller, lighter unit.

CurrentSold in Canada
Input
10–150 MBH
Output (max)
—
AFUE
—

The Navien NPE-180A2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 10,000 to 150,000 BTU/h at 0.95 UEF with up to 8.4 GPM at a 35°F rise.

Natural gasPropaneDHW-only (tankless)
CurrentSold in Canada
Input
12–180 MBH
Output (max)
—
AFUE
—

The Navien NPE-210A2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 12,000 to 180,000 BTU/h at 0.95 UEF with up to 10.1 GPM at a 35°F rise.

Natural gasPropaneDHW-only (tankless)

Frequently asked questions

Is there an efficiency difference between the two?

No. Both print 0.95 UEF per the official product pages; UEF is a dimensionless factor and both models carry the same rating.

Which NPE-A2 size fits a two-bathroom home?

Sizing depends on fixture flow rates, incoming water temperature and simultaneous use, not bathroom count. The 180A2 publishes 8.4 GPM and the 210A2 10.1 GPM at a 35°F rise; a licensed contractor should verify the demand calculation.

Do both models support recirculation?

Yes. Both are ComfortFlow A2 models with a built-in buffer tank and recirculation pump, which is what distinguishes the A2 line from the standard S2 models.

Not sure which one fits your home?

A consultation includes a heat-loss review so the size is right the first time.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate