Navien
Navien NPE-210A2
- Input
- 12–180 MBH
- Output (max)
- —
- AFUE
- —
The Navien NPE-210A2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 12,000 to 180,000 BTU/h at 0.95 UEF with up to 10.1 GPM at a 35°F rise.
Canada-wide gas boiler information · On-site service in Greater Vancouver, BC
Boilers.ca is a brand of ROMA Heating & Cooling · Licensed gas contractor LGA0202903
Comparison
Verdict in brief
The NPE-240A2 is the largest ComfortFlow tankless model: 13,300 to 199,900 BTU/h against the NPE-210A2's 12,000 to 180,000, with flow at a 35°F rise of 11.2 against 10.1 GPM. Both are 0.95 UEF, 77 lb, and share the same cabinet and connections.
Published manufacturer figures. Input and output are kept separate; blanks mean the manufacturer did not publish that value.
| Specification | Navien NPE-210A2 | Navien NPE-240A2 |
|---|---|---|
| Input, minimum | 12 MBH | 13.3 MBH |
| Input, maximum | 180 MBH | 199.9 MBH |
| Uniform Energy Factor (UEF) | 0.95 UEF | 0.95 UEF |
| Maximum flow rate at 35°F (19.4°C) rise | 10.1 GPM | 11.2 GPM |
| Weight | 77 lb | 77 lb |
The NPE-210A2 and NPE-240A2 are the upper pair of Navien's premium ComfortFlow line, both condensing tankless water heaters at 0.95 UEF with built-in recirculation and buffer tanks. Neither is a boiler: they heat domestic water only, and any space-heating need is served by a separate boiler or a combi.
The 240A2 adds 19,900 BTU/h of input ceiling (199,900 against 180,000) and 1.1 GPM of published flow at a 35°F rise (11.2 against 10.1), which matters in cold-inlet conditions or where several fixtures run at once. Its minimum fire of 13,300 BTU/h is slightly higher than the 210A2's 12,000, but both modulate well below a single shower's demand.
The two units are otherwise identical: 77 lb, 17.3 W x 27.4 H x 13.2 D in, 3/4" NPT water and gas connections, indoor or outdoor installation, and the same approvals (CSA, NSF-5, SCAQMD 1146.2). The sizing decision follows the peak hot-water demand calculation.
Navien
The Navien NPE-210A2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 12,000 to 180,000 BTU/h at 0.95 UEF with up to 10.1 GPM at a 35°F rise.
Navien
The Navien NPE-240A2 is a condensing tankless water heater — a DHW-only appliance, not a boiler — firing 13,300 to 199,900 BTU/h at 0.95 UEF with up to 11.2 GPM at a 35°F rise.
11.2 GPM against 10.1 GPM at a 35°F (19.4°C) temperature rise, with a maximum input of 199,900 against 180,000 BTU/h.
Yes. Both weigh 77 lb and measure 17.3 W x 27.4 H x 13.2 D in with the same connections and installation options.
When the peak-demand calculation approaches or exceeds the 210A2's 10.1 GPM at a 35°F rise, or when cold incoming water shortens the usable flow. Otherwise the two are functionally identical.
A consultation includes a heat-loss review so the size is right the first time.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.