Skip to content
Boilers.caby ROMA Heating & Cooling

Problem

Combi hot water temperature fluctuating

A combi boiler whose hot water swings between hot and cold: why a combination boiler struggles to hold temperature, the flow, sensor and heat-exchanger faults behind the swings, and how the fix is measured.

What is happening

A combination boiler heats tap water on demand: when a tap opens, a flow sensor tells the control, the boiler fires, and a plate heat exchanger transfers heat to the domestic water passing through it. The control's job is to match the firing rate to the flow, and when that match breaks down, the temperature at the tap wavers.

Fluctuating means different things to different households: water that runs hot then cold in a rhythm, water that cools sharply when a second tap opens, or showers that wander between comfortable and scalding. The pattern matters, because a problem at one fixture points at that fixture or its piping, while a problem at every tap points back at the boiler.

Safe things to check at home

Run the hot water at a single tap and watch the boiler's display if you can see it: note whether the boiler fires steadily, modulates, or shows an alert, and write down any code to look up on this site's brand error-code pages. Check whether the problem follows the tap, because a shower that fluctuates while the kitchen sink stays steady points at the shower valve or its supply rather than the boiler.

Confirm the cold-water inlet valve to the boiler is fully open if it is accessible, since a partially closed inlet starves the boiler of flow, and note whether the swings happen only when other water is being used at the same time. Do not adjust the boiler's internal settings or open the casing; temperature and firing settings that the manual reserves for installers are part of the technician's diagnosis.

Common causes

The classic cause is scale: mineral deposits inside the domestic heat exchanger narrow its passages and insulate its metal, so the water either overheats or cannot absorb enough heat, and the control hunts between the two. Varying incoming water temperature through the year, or a fouled flow sensor that reads the tap incorrectly, produces the same hunting from a different direction.

Boiler-side faults include a temperature sensor reading incorrectly, a gas valve or fan that cannot modulate smoothly, and a control that was never configured for the home's incoming water temperature. The plumbing side matters too: a shower's pressure-balancing or thermostatic valve, long shared pipe runs, and simultaneous draws elsewhere in the house can each produce temperature swings that have nothing to do with the boiler.

When to call

Call when the fluctuation is steady and uncomfortable, when it appeared after years of steady performance, or when the boiler cannot hold a constant temperature at a single tap. A boiler that hunts constantly is also working harder than it should, and the condition behind the swings rarely improves by itself.

Describe the pattern when you call: which taps, which weather, and whether the boiler's display changes with the swings. Call ROMA Heating & Cooling at 778-909-5731 during business hours, and a technician will bring the meters and thermometers the diagnosis needs.

What a licensed technician will do

A technician measures the real numbers: flow rate from the tap, incoming and outgoing water temperatures, and the boiler's modulation through a full draw, comparing them with the values in the manual. The domestic heat exchanger, flow sensor and temperature sensors are tested in sequence rather than replaced on suspicion.

Where scale is confirmed, the domestic heat exchanger is flushed or descaled to the manufacturer's procedure, sensors and valves are replaced if they failed their tests, and control settings are corrected where the manual allows. The tap is then run again to confirm the temperature holds through a long draw, so the fix is verified at the point where the problem was felt.

Frequently asked questions

Why does my shower temperature swing when the dishwasher runs?

A combi boiler serves one draw pattern at a time, and a sudden second draw changes the flow and pressure the boiler sees. If the swings are severe, the boiler's response or the home's piping deserves a check.

Does hard water cause fluctuating hot water?

Frequently. Scale inside the domestic heat exchanger makes temperature control hunt between too hot and too cold. Descaler service is part of combi maintenance in hard-water areas.

Is fluctuating hot water dangerous?

The risk is scalding when the water runs hotter than expected, especially for children and seniors. A boiler that swings widely should be diagnosed rather than worked around.

Talk to a boiler technician

Describe what the boiler is doing and get a straight answer about the next step.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 8, 2026. Last updated September 8, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate