Skip to content
Boilers.caby ROMA Heating & Cooling

Problem

Gas odour near the boiler

A gas smell near the boiler is an emergency before it is a diagnosis: the response steps FortisBC asks for, why boilers should never be left to leak, and how the utility and a licensed contractor investigate afterwards.

Safety first

If you smell gas, leave the building and call FortisBC at 1-800-663-9911 or 911 from outside before anything else. Do not operate light switches, appliances or anything electrical on your way out, do not use the phone inside, and do not try to find the leak yourself.

Do not touch the gas shut-off valve or anything on the boiler; the gas utility and licensed contractors are the ones who handle the supply. The rotten-egg or sulfur smell is added to natural gas on purpose so that leaks announce themselves, and FortisBC's published response steps treat every whiff as real, whether it is strong or faint.

What is happening

Natural gas is odourless as it comes from the ground, so FortisBC adds a chemical odorant that smells like sulfur or rotten eggs; that smell is the earliest warning of a leak. Around a boiler, leaks can develop at the gas line connections, inside the appliance, or in the piping and meter feeding it, and they can be caused by vibration, corrosion, a failed valve or seal, or disturbance during other work.

A boiler that has been failing to light, or that has needed repeated resets after ignition faults, deserves extra attention because every failed ignition trial moves gas that did not burn. But a gas smell does not require a boiler to be misbehaving: a slow leak from a fitting can exist while the appliance works perfectly, which is why the smell itself is the emergency.

Safe things to check at home

There are no safe do-it-yourself checks for a gas smell; the response is to leave the building, call from outside, and let the gas utility respond, which in BC means FortisBC's emergency line first. If the smell is strong, do not delay the call to investigate further, and do not switch anything electrical on or off on the way out.

Once the utility has cleared the building, the boiler itself still needs attention: the utility may isolate the supply, and a licensed gas contractor then finds and repairs the leak inside the appliance or its piping. Homeowners can help by knowing where the boiler is and whether any recent work touched the gas line, because that history helps both the utility and the contractor.

Common causes

Leaks form where gas is handled: at threaded fittings that were never fully tightened or sealed, at the gas valve and its connections inside the boiler, at the flexible connector to the appliance, and at older piping that has corroded or been disturbed by vibration or nearby work. A smell that appears only while the boiler fires points inside the appliance, while a constant smell points at the supply piping or its connections.

Faults elsewhere can produce a smell as well: a gas appliance that has failed to light repeatedly, a line that was shut off and never capped properly, or work in the building that nicked or loosened piping. What almost never happens is a gas smell that is safe to ignore, which is why utility guidance and this site's content treat it as an emergency first and a repair later.

When to call

Call the gas utility from outside the moment you smell gas; that step comes before any conversation about the boiler. Once the building is safe and the utility has done its part, call ROMA Heating & Cooling at 778-909-5731 during business hours to have the boiler's own gas side inspected and repaired under Technical Safety BC's permit system, and verified before the appliance returns to service.

If you smell gas only occasionally, or only near the boiler when it fires, treat it as the same emergency. A small leak can become a larger one, and the odorant is added precisely so that no level of smell is treated as acceptable.

What a licensed technician will do

When a gas contractor investigates, the supply is isolated first, then the appliance and its piping are pressure-tested or leak-checked at every connection, and the faulty fitting, valve or component is replaced to the manufacturer's specification. Work on gas piping and gas valves is performed by licensed contractors under permits issued through Technical Safety BC.

After the repair the appliance is leak-checked again and run through its firing sequence with combustion verified, and the homeowner is told what failed and why. The leak is closed with its cause explained, not merely patched, so the same failure does not quietly rebuild itself.

Frequently asked questions

I smell gas only near the boiler. Is that still an emergency?

Yes. Call FortisBC at 1-800-663-9911 or 911 from outside the building before anything else, even if the smell is faint or only appears when the boiler fires.

Can I check a gas smell with soapy water?

No. Leave the building and call the gas utility from outside. Leak testing on gas piping and appliances is work for licensed contractors, not for homeowner experiments.

The utility found nothing. Why do I still smell gas?

The smell can come from outside sources, from appliances the utility did not isolate, or from a leak that only appears under certain conditions. A licensed contractor can test the boiler and its connections separately.

Talk to a boiler technician

Describe what the boiler is doing and get a straight answer about the next step.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 8, 2026. Last updated September 8, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate