Takagi T-M32 551 — Abnormal Gas Solenoid Valve
551
Abnormal gas solenoid valve. An abnormal gas solenoid valve; check for connection or breakage of wires and burn marks on the computer board. The table classifies it as Error.
Applies to
This electronics fault code is displayed by the T-M32 control (7-Seg LED and remote controller error codes) on T-M32 models (T-M32 and T-M32 ASME, indoor/outdoor), as documented in Takagi T-M32 / T-M32 ASME Installation Manual and Owner's Guide, doc 63T051-5, troubleshooting error codes (63T051-5). Codes can differ between controller generations, so always check the manual that matches your unit.
Controller: T-M32 control (7-Seg LED and remote controller error codes). Source manual: 63T051-5.
Why a code is not a diagnosis
An electronics code points at the control board, memory or firmware. It is often triggered by poor incoming power or voltage backfeed from other wiring rather than by the appliance itself.
Safe things to observe
- Note the code and whether it appeared after electrical work or a power event.
Do not
- Do not open the control module.
- Do not repeatedly power-cycle to clear a recurring board code.
How professional service helps
- A technician checks supply voltage and grounding, follows the manual's reset sequence and replaces the module only if the code returns.
- Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Takagi T-M32 / T-M32 ASME Installation Manual and Owner's Guide, doc 63T051-5, troubleshooting error codes · 63T051-5 · accessed September 9, 2026
Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.