Skip to content
Boilers.caby ROMA Heating & Cooling

Dunkirk Boilers · Error codes

Dunkirk XEB Series 4 65 — Hard Lockout- Temperature Above Limit

65

LockoutDunkirk XEB Series 4 gas-fired steam boilers (integrated boiler control error codes, I&O 240013870 Rev A)

Hard Lockout- Temperature above limit. The control sensed a water temperature too high for safe boiler operation; check that water is circulating properly and there is no air in the system, and check the sensor reading. This hard lockout will not expire and requires an operator reset. The table classifies it as Hard Lockout.

Applies to

This sensor fault code is displayed by the Integrated boiler control (Honeywell 4200 series, numeric error codes) on XEB Series 4 models (XEB-2 through XEB-6 steam boilers), as documented in XEB Series 4 Installation, Operation & Maintenance Manual, PN 240013870 Rev. A (02/24/2025), Appendix A Table A-2 Operation Error Codes (240013870 Rev. A). Codes can differ between controller generations, so always check the manual that matches your unit.

Controller: Integrated boiler control (Honeywell 4200 series, numeric error codes). Source manual: 240013870 Rev. A (2025-02-24).

Why a code is not a diagnosis

A sensor code usually means the sensor, its wiring or its mounting is faulty; the physical condition the sensor measures (temperature, pressure, flow) may be perfectly normal.

Safe things to observe

  • Note the code; there is no homeowner-accessible check for sensor circuits.
  • If the appliance still runs, watch whether the code returns and report it when you call.

Do not

  • Do not open the appliance to test or replace sensors yourself.

How professional service helps

  1. A technician measures the sensor and harness against the manual's values and replaces the faulty component.
  2. Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.

Where ROMA provides on-site service

On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.

See all service areas

Parts and service

Parts commonly involved

These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.

Service for this alert

  • Gas Boiler Repair

    Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…

  • Emergency Boiler Repair

    Priority gas boiler repair for homes and buildings in Greater Vancouver with no heat, no hot water, a locked-out boiler or a leak.

Every boiler part explained — what it does, how it fails and what a technician checks.

Documented for Dunkirk Boilers XEB Series 4.

Frequently asked questions

Can I clear this code myself?

Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.

Boiler locked out? Call with the alert text ready.

The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate