Laars Heating Systems · Error codes
Laars FT Series Floor 45 — Air Pressure Sensor Fault
45
Air pressure sensor fault. The air pressure sensor has a fault, so check the APS connection and replace the APS if the problem persists. The table classifies it as Soft Lock.
Applies to
This venting or air-supply fault code is displayed by the Laars FT floor control on FT Series Floor models (FTHF199 heat-only and FTCF199 combi), as documented in FT Series Floor Heat-Only Installation and Operation Instructions, Document 1510B (the FTCF combi manual 1505C prints the same code table) (1510B). Codes can differ between controller generations, so always check the manual that matches your unit.
Controller: Laars FT floor control. Source manual: 1510B.
Why a code is not a diagnosis
A venting or air-supply code points at the combustion-air path: a blocked terminal, a restricted flue, a failed fan, or a condensate restriction. It does not say which, and running an appliance with a blocked flue is unsafe.
Safe things to observe
- If a carbon-monoxide alarm sounds anywhere in the building, leave immediately and call 911 from outside.
- From a safe distance, check that the vent terminal and combustion-air inlet are not blocked.
- Do not run the appliance while a blockage is suspected.
Do not
- Do not put anything into the vent or air-intake openings.
- Do not remove or modify vent pipe.
How professional service helps
- A technician inspects the full vent and combustion-air path, clears blockages and checks the fan.
- Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- FT Series Floor Heat-Only Installation and Operation Instructions, Document 1510B (the FTCF combi manual 1505C prints the same code table) · 1510B · accessed September 7, 2026
Facts checked September 7, 2026. Last updated September 7, 2026. Technical reviewer: not yet assigned.