HTP Elite Fire Tube Ultra 1 P3 — Inadequate Circulation or Missing Water: T Return - T Supply > 18°f
1 P3
Inadequate Circulation or Missing Water: T Return - T Supply > 18°F. Warning of inadequate circulation or missing water with return minus supply temperature greater than 18°F. Check the water pressure, purge air from the central heating circuit, and check the temperature probes and circulation pump. The table classifies it as Warning.
Applies to
This low-water or pressure protection code is displayed by the EFTU control (group fault codes) on EFTU models (EFTU-085WBN through EFTU-199WCN), as documented in Elite Fire Tube Ultra Installation Start-Up Maintenance Parts Warranty, LP-723 (2.23.22) (LP-723). Codes can differ between controller generations, so always check the manual that matches your unit.
- HTP Ultra (UFT & EFTU)
- HTP UFT-80W
- HTP UFT-100W
- HTP UFT-120W
- HTP UFT-140W
- HTP UFT-175W
- HTP UFT-199W
- HTP EFTU-85WBN
- HTP EFTU-110WBN
- HTP EFTU-150WBN
- HTP EFTU-199WBN
- HTP EFTU-110WCN
- HTP EFTU-150WCN
- HTP EFTU-199WCN
Controller: EFTU control (group fault codes). Source manual: LP-723 (2022-02).
Why a code is not a diagnosis
A water-pressure or low-water code can mean a genuine leak or empty system, a failed expansion tank, a faulty fill valve, or a sensor problem. The appliance does not distinguish these.
Safe things to observe
- Read the pressure gauge and compare it with the normal cold-system pressure your installer set.
- Look for drips or wet spots near the appliance, pipes and the relief-valve discharge.
Do not
- Do not keep re-pressurizing a system that keeps losing water.
- Do not cap a relief-valve discharge pipe.
How professional service helps
- A technician finds and repairs the leak, checks the expansion tank and fill assembly, and verifies the sensor circuit.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Boiler sensors (thermistors)
Boiler sensors are small temperature probes, usually thermistors, that tell the control how hot the water and flue gases are so it can fire safely…
What a technician checks →Circulator pump
The circulator is the pump that moves heated water from a boiler out to the radiators, baseboards or in-floor loops and back again.
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for HTP Ultra (UFT & EFTU).
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Elite Fire Tube Ultra Installation Start-Up Maintenance Parts Warranty, LP-723 (2.23.22) · LP-723 · accessed September 8, 2026
Facts checked September 8, 2026. Last updated September 8, 2026. Technical reviewer: not yet assigned.