U.S. Boiler Company · Error codes
U.S. Boiler Alpine 23 — 24vac Voltage Low/high
23
24VAC Voltage Low/High. The Sage2.X control 24 VAC power is high or low, so check the 24 VAC power wiring, harness, and transformer for loose connections or a short to ground. The table classifies it as Hard Lockout.
Applies to
This fault code is displayed by the Sage2.X touchscreen control on Alpine models (ALP080B, ALP105B, ALP150B, ALP210B, ALP285B, ALP399C), as documented in Alpine Installation, Operating and Service Instructions, doc 103448-12 (8/24), Sections XIV.F–XIV.G soft and hard lockout tables (103448-12). Codes can differ between controller generations, so always check the manual that matches your unit.
- U.S. Boiler Company Alpine
- U.S. Boiler Company Alpine ALP080B
- U.S. Boiler Company Alpine ALP105B
- U.S. Boiler Company Alpine ALP150B
- U.S. Boiler Company Alpine ALP210B
- U.S. Boiler Company Alpine ALP285B
- U.S. Boiler Company Alpine ALP399C
Controller: Sage2.X touchscreen control. Source manual: 103448-12 (2024-08).
Why a code is not a diagnosis
The code reports the condition the control detected; the underlying cause must be confirmed on site by a licensed technician using the manufacturer's procedure.
Safe things to observe
- Note the exact code, when it appears and what the appliance was doing.
- If the appliance has stopped, call a technician rather than repeatedly restarting it.
- If you smell gas, stop, go outside and call your gas utility's emergency line or 911 before anything else.
Do not
- Do not ignore a code that returns after a reset.
How professional service helps
- A licensed technician diagnoses the cause with the manufacturer's test procedure.
- Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Transformer
The transformer is the small component inside the boiler that steps household 120-volt power down to the low voltage the controls use — typically 24…
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
- Emergency Boiler Repair
Priority gas boiler repair for homes and buildings in Greater Vancouver with no heat, no hot water, a locked-out boiler or a leak.
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for U.S. Boiler Company Alpine.
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Alpine Installation, Operating and Service Instructions, doc 103448-12 (8/24), Sections XIV.F–XIV.G soft and hard lockout tables · 103448-12 · accessed September 9, 2026
Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.