Bosch Thermotechnology · Error codes
Buderus GB162 6L 229 — Insufficient Flame Activity (ionization Current) during the Burner Procedure
6L 229
Insufficient flame activity (ionization current) during the burner procedure. Insufficient flame activity (ionization current) was measured during the burner procedure, so there is no heating operation and no DHW, and this fault code may deactivate again automatically after a specific time without reset. The table classifies it as Blocking fault code, reset required no, UBA3 LED off.
Applies to
This domestic hot water fault code is displayed by the UBA3 control (display codes and LED flags) on Buderus GB162 models (80–200), as documented in Buderus GB162 Service Instructions, doc 6720614965_05 (6720614965_05). Codes can differ between controller generations, so always check the manual that matches your unit.
Controller: UBA3 control (display codes and LED flags). Source manual: 6720614965_05 (2012-11).
Why a code is not a diagnosis
A DHW code involves the hot-water side: sensors, flow, the mixing/bypass valve or the DHW heat exchanger. It does not say whether the fix is a sensor, a valve or a flush.
Safe things to observe
- Note the code and whether the problem follows a hot-water draw or appears at all times.
Do not
- Do not open the appliance to test DHW components yourself.
How professional service helps
- A technician tests the DHW sensors, flow switch and valve circuits, and cleans the DHW path where the manual directs.
- Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Burner assembly
The burner assembly is where gas and air meet and burn inside a boiler, and its condition decides whether combustion is clean or makes carbon…
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for Bosch Thermotechnology Buderus GB162.
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Buderus GB162 Service Instructions, doc 6720614965_05 · 6720614965_05 · accessed September 7, 2026
Facts checked September 7, 2026. Last updated September 7, 2026. Technical reviewer: not yet assigned.