Skip to content
Boilers.caby ROMA Heating & Cooling

HTP · Error codes

HTP Elite FT F03 — Return Sensor Failure

F03

LockoutHTP Elite FT legacy boilers (926 SIT control, manual LP-387)

Return sensor failure. The return temperature sensor of the boiler has failed. Check circulator pump operation and ensure adequate flow by confirming less than a 50°F rise from the return thermistor to the supply thermistor in the status menu. Troubleshoot the thermistor by following the F02 steps. The table classifies it as Lockout (Manual Reset).

Applies to

This sensor fault code is displayed by the 926 SIT control on Elite FT models (EFT-55 through EFT-399), as documented in Elite FT Installation Manual, LP-387 Rev. 011 Rel. 009 (2.19.21), Table 31 (LP-387). Codes can differ between controller generations, so always check the manual that matches your unit.

Controller: 926 SIT control. Source manual: LP-387.

Why a code is not a diagnosis

A sensor code usually means the sensor, its wiring or its mounting is faulty; the physical condition the sensor measures (temperature, pressure, flow) may be perfectly normal.

Safe things to observe

  • Note the code; there is no homeowner-accessible check for sensor circuits.
  • If the appliance still runs, watch whether the code returns and report it when you call.

Do not

  • Do not open the appliance to test or replace sensors yourself.

How professional service helps

  1. A technician measures the sensor and harness against the manual's values and replaces the faulty component.
  2. Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.

Where ROMA provides on-site service

On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.

See all service areas

Parts and service

Parts commonly involved

These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.

Service for this alert

  • Gas Boiler Repair

    Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…

  • Emergency Boiler Repair

    Priority gas boiler repair for homes and buildings in Greater Vancouver with no heat, no hot water, a locked-out boiler or a leak.

Every boiler part explained — what it does, how it fails and what a technician checks.

Documented for HTP Elite FT (EFT) (discontinued).

Frequently asked questions

Can I clear this code myself?

Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.

Boiler locked out? Call with the alert text ready.

The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 8, 2026. Last updated September 8, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate