Utica cast iron LWCO LOW WATER (blinking) — Low Water Cut-off Lockout (manual Reset Mode)
LWCO LOW WATER (blinking)
Low water cut-off lockout (manual reset mode). When the low water condition is sustained for 30 seconds with manual reset mode active, the Low Water light blinks to indicate the control has locked out the burner. Press the Test/Settings button to reset after the condition is resolved. Do not add water until the boiler has fully cooled. The table classifies it as lockout.
Applies to
This low-water or pressure protection code is displayed by the HydroStat-style control (LED diagnostics) on MGB-K and MGC Series 4 cast-iron models, as documented in Utica MGB/DXL Boiler Manual, doc 240013750 Rev B (LED diagnostics) — MGC Series 4 in 240013818 Rev A (240013750 Rev B). Codes can differ between controller generations, so always check the manual that matches your unit.
- Utica Boilers MGB-K (MGB Series)
- Utica Boilers MGC Series 4 (MGC-8D/9D)
- Utica MGB-060K
- Utica MGB-095K
- Utica MGB-120K
- Utica MGB-150K
- Utica MGB-175K
- Utica MGB-205K
- Utica MGB-235K
- Utica MGC-8D
- Utica MGC-9D
Controller: HydroStat-style control (LED diagnostics). Source manual: 240013750 Rev B.
Why a code is not a diagnosis
A water-pressure or low-water code can mean a genuine leak or empty system, a failed expansion tank, a faulty fill valve, or a sensor problem. The appliance does not distinguish these.
Safe things to observe
- Read the pressure gauge and compare it with the normal cold-system pressure your installer set.
- Look for drips or wet spots near the appliance, pipes and the relief-valve discharge.
Do not
- Do not keep re-pressurizing a system that keeps losing water.
- Do not cap a relief-valve discharge pipe.
How professional service helps
- A technician finds and repairs the leak, checks the expansion tank and fill assembly, and verifies the sensor circuit.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Burner assembly
The burner assembly is where gas and air meet and burn inside a boiler, and its condition decides whether combustion is clean or makes carbon…
What a technician checks →Low-water cutoff
A low-water cutoff is the safety device that stops a boiler from firing when there is not enough water inside it.
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
- Emergency Boiler Repair
Priority gas boiler repair for homes and buildings in Greater Vancouver with no heat, no hot water, a locked-out boiler or a leak.
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for Utica Boilers MGB-K (MGB Series) and Utica Boilers MGC Series 4 (MGC-8D/9D).
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Utica MGB/DXL Boiler Manual, doc 240013750 Rev B (LED diagnostics) — MGC Series 4 in 240013818 Rev A · 240013750 Rev B · accessed September 9, 2026
Facts checked September 9, 2026. Last updated September 9, 2026. Technical reviewer: not yet assigned.