Crown Boiler Co. · Error codes
Crown Phantom II E29 — Excessive Reset Selection
E29
Excessive Reset Selection. The control reset button has been selected too often [29.0]. Cycle power to the control and press the reset button above the local display to clear. The table classifies it as Lockout.
Applies to
This electronics fault code is displayed by the Phantom II control (H01–H32 / E04–E29 codes) on Phantom II models (PHTM2080H, PHTM2120H, PHTM2150H, PHTM2180H, PHTM2136C, PHTM2200C), as documented in Phantom II Heat-Only Installation and Operation Manual, doc 110332-07 (9/25) (110332-07). Codes can differ between controller generations, so always check the manual that matches your unit.
- Crown Boiler Co. Phantom II
- Crown Phantom II PHTM2080H
- Crown Phantom II PHTM2120H
- Crown Phantom II PHTM2150H
- Crown Phantom II PHTM2180H
- Crown Phantom II Combi PHTM2136C
- Crown Phantom II Combi PHTM2200C
Controller: Phantom II control (H01–H32 / E04–E29 codes). Source manual: 110332-07 (2025-09).
Why a code is not a diagnosis
An electronics code points at the control board, memory or firmware. It is often triggered by poor incoming power or voltage backfeed from other wiring rather than by the appliance itself.
Safe things to observe
- Note the code and whether it appeared after electrical work or a power event.
Do not
- Do not open the control module.
- Do not repeatedly power-cycle to clear a recurring board code.
How professional service helps
- A technician checks supply voltage and grounding, follows the manual's reset sequence and replaces the module only if the code returns.
- Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Phantom II Heat-Only Installation and Operation Manual, doc 110332-07 (9/25) · 110332-07 · accessed September 8, 2026
Facts checked September 8, 2026. Last updated September 8, 2026. Technical reviewer: not yet assigned.