Crown Boiler Co. · Error codes
Crown Phantom II E05 — Low Water Flow
E05
Low Water Flow. Boiler water flow switch does not detect water flow after 5 retries [05.2], temperature rise between supply and return exceeds 63°F [05.3], or the flow switch contact is closed when it should be open [05.4]. Correct the flow problem: purge air, verify pump and piping, and check the flow switch. The table classifies it as Lockout (manual reset).
Applies to
This low-water or pressure protection code is displayed by the Phantom II control (H01–H32 / E04–E29 codes) on Phantom II models (PHTM2080H, PHTM2120H, PHTM2150H, PHTM2180H, PHTM2136C, PHTM2200C), as documented in Phantom II Heat-Only Installation and Operation Manual, doc 110332-07 (9/25) (110332-07). Codes can differ between controller generations, so always check the manual that matches your unit.
- Crown Boiler Co. Phantom II
- Crown Phantom II PHTM2080H
- Crown Phantom II PHTM2120H
- Crown Phantom II PHTM2150H
- Crown Phantom II PHTM2180H
- Crown Phantom II Combi PHTM2136C
- Crown Phantom II Combi PHTM2200C
Controller: Phantom II control (H01–H32 / E04–E29 codes). Source manual: 110332-07 (2025-09).
Why a code is not a diagnosis
A water-pressure or low-water code can mean a genuine leak or empty system, a failed expansion tank, a faulty fill valve, or a sensor problem. The appliance does not distinguish these.
Safe things to observe
- Read the pressure gauge and compare it with the normal cold-system pressure your installer set.
- Look for drips or wet spots near the appliance, pipes and the relief-valve discharge.
Do not
- Do not keep re-pressurizing a system that keeps losing water.
- Do not cap a relief-valve discharge pipe.
How professional service helps
- A technician finds and repairs the leak, checks the expansion tank and fill assembly, and verifies the sensor circuit.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Low-water cutoff
A low-water cutoff is the safety device that stops a boiler from firing when there is not enough water inside it.
What a technician checks →Flow switch
A flow switch proves that water is actually moving through the boiler before it fires and while it runs.
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
- Emergency Boiler Repair
Priority gas boiler repair for homes and buildings in Greater Vancouver with no heat, no hot water, a locked-out boiler or a leak.
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for Crown Boiler Co. Phantom II.
Frequently asked questions
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Phantom II Heat-Only Installation and Operation Manual, doc 110332-07 (9/25) · 110332-07 · accessed September 8, 2026
Facts checked September 8, 2026. Last updated September 8, 2026. Technical reviewer: not yet assigned.