Skip to content
Boilers.caby ROMA Heating & Cooling

Rinnai · Series

Rinnai i-Series+ Solo

Rinnai's Canadian I-Series+ solo boilers are the heating-only members of the family: IP060S through IP150S fire 15,000 to 150,000 BTU/h with no built-in hot-water production and are documented here from EN I&O manual 800000191(02). The two large solos, IP175S and IP199S, are on rinnai.ca (IP175S marked available September 2024) but stay draft models here pending review of their raster-only manual.

Current seriesSold in CanadaNatural gasPropaneresidential

Series facts

Type
condensing
Efficiency
96% AFUE
Fuel
Natural gas or propane per the manual; units ship configured for natural gas and gas-supply pressure is NG 3.5-10.5 in. W.C. or propane 8.0-13.5 in. W.C. per spec Table 2.
Venting
Vent connection is 2" nominal PVC/polypropylene (twin pipe) or 3" x 5" concentric; per the solo I&O manual (Table 20) maximum equivalent length is 75 ft in 2" and 160 ft in 3" pipe.
Models documented
6

"Up to 96% AFUE" per Rinnai Canada marketing copy on the I-SERIES+ pages and the Canadian brochure. The I&O manual spec tables print no AFUE figure and no per-model rating is published, so this is the manufacturer's claim, not a measured per-model figure.

About the i-Series+ Solo

The I-Series+ solo is the wall-hung, indoor, gas-fired condensing heat-only boiler of Rinnai's current Canadian residential line — the name Rinnai Canada uses is "solo" for a heating-only boiler with no domestic hot water produced inside the unit. Four models cover the ≤150k range: IP060S, IP090S, IP120S and IP150S, firing from a 15,000 BTU/h minimum up to 60,000, 90,000, 120,000 or 150,000 BTU/h, with specifications and inputs recorded from the English I&O manual, doc 800000191(02) (10/2024).

Hot water comes from an indirect tank controlled by the boiler: the manual's default is domestic indirect-tank recovery priority, parameter 33 can be set to "b" for simultaneous central-heating and indirect-tank operation, and parameter 29 selects thermostat or thermistor tank control. The control shows fault codes without an E prefix, and solo-only rows such as 371 (indirect thermistor) and 831 (indirect tank temperature) appear in the solo manual's tables.

The two large solos, IP175S and IP199S (175,000 and 199,000 BTU/h), carry "available September 2024" launch copy and French documentation on rinnai.ca, but their English I&O manual is raster-only, so Boilers.ca documents them as draft models pending review. Health Canada recall RA-77507 covers both of these large solo models — see each model's record and the Health Canada alert.

Highlights

  • Heating-only condensing solos: IP060S through IP150S (15-150 MBH input)
  • Documented from EN I&O manual 800000191(02) (10/2024); CRN 2089.9CL (Canada)
  • No built-in DHW: hot water via an indirect tank with recovery priority by default
  • Uniform venting: 75 equivalent ft in 2" or 160 in 3" per the solo manual
  • IP175S and IP199S sold in Canada but draft-only here (raster I&O manual)
  • Codes print without an E prefix; solo-only rows (371, 831) marked in the manual

Rinnai Limited Warranty (I&O manual warranty section, Table 56): 12-year heat exchanger, 5-year parts and components, and 1-year reasonable labour for residential applications in the US and Canada, first installation site only; registration within 90 days serves as proof of purchase.

Models

i-Series+ Solo models

One canonical page per model with input, output and efficiency kept separate.

CurrentSold in Canada
Input
15–60 MBH
Output (max)
—
AFUE
96 %

The Rinnai IP060S is the smallest I-Series+ solo: a heating-only condensing boiler firing 15 to 60 MBH of input with no built-in hot-water production, documented from the solo I&O manual 800000191(02) at 62.6 lb.

Natural gasPropaneHeating-only
CurrentSold in Canada
Input
15–90 MBH
Output (max)
—
AFUE
96 %

The Rinnai IP090S is the mid-size I-Series+ solo: a heating-only condensing boiler firing 15 to 90 MBH of input at the same 62.6 lb and small-chassis footprint as the IP060S, with hot water via an indirect tank.

Natural gasPropaneHeating-only
CurrentSold in Canada
Input
15–120 MBH
Output (max)
—
AFUE
96 %

The Rinnai IP120S steps the heating-only solo line up to 120 MBH of input (15-120 MBH) on the 10.9 sq ft heat exchanger at 64.8 lb per the manual, with hot water handled by an indirect tank.

Natural gasPropaneHeating-only
CurrentSold in Canada
Input
15–150 MBH
Output (max)
—
AFUE
96 %

The Rinnai IP150S is the largest fully documented I-Series+ solo: a heating-only condensing boiler firing 15 to 150 MBH of input at 64.8 lb per the manual, controlling an indirect tank for domestic hot water.

Natural gasPropaneHeating-only
CurrentSold in Canada
Input
15–175 MBH
Output (max)
—
AFUE
96 %

The Rinnai IP175S is the 175k heating-only I-Series+ solo on the large chassis, marketed on rinnai.ca as available since September 2024 and documented on Boilers.ca from the EN I&O manual (doc 800000216) at 112.4 lb. It is named in Health Canada recall RA-77507.

Natural gasPropaneHeating-only
CurrentSold in Canada
Input
15–199 MBH
Output (max)
—
AFUE
96 %

The Rinnai IP199S is the top heating-only I-Series+ solo at 199 MBH of central-heating input on the large chassis, documented on Boilers.ca from the EN I&O manual (doc 800000216) at 112.4 lb. It is named in Health Canada recall RA-77507.

Natural gasPropaneHeating-only

Compare models in this series

Comparison of Rinnai IP060S and Rinnai IP090S and Rinnai IP120S and Rinnai IP150S and Rinnai IP175S and Rinnai IP199S
SpecificationRinnai IP060SRinnai IP090SRinnai IP120SRinnai IP150SRinnai IP175SRinnai IP199S
Heating input, minimum15 MBH15 MBH15 MBH15 MBH15 MBH15 MBH
Heating input, maximum60 MBH90 MBH120 MBH150 MBH175 MBH199 MBH
output-max——————
Efficiency (AFUE)96 %96 %96 %96 %96 %96 %
turndown——————
Max. equivalent vent length, 3"160 ft160 ft160 ft160 ft160 ft160 ft
Max. equivalent vent length, 2"75 ft75 ft75 ft75 ft75 ft75 ft
Weight62.6 lb62.6 lb64.8 lb64.8 lb112.4 lb112.4 lb

Read the full comparison: Rinnai IP060S vs IP090S →

Read the full comparison: Rinnai IP090S vs IP120S →

Read the full comparison: Rinnai IP120S vs IP150S →

Read the full comparison: Rinnai IP150S vs Rinnai IP175S →

Error codes and alerts

i-Series+ Solo alerts

  • 100i-Series+ front-panel control
  • 110i-Series+ front-panel control
  • 120i-Series+ front-panel control
  • 140i-Series+ front-panel control
  • 150i-Series+ front-panel control
  • 161i-Series+ front-panel control
  • 170i-Series+ front-panel control
  • 180i-Series+ front-panel control
  • 190i-Series+ front-panel control
  • 210i-Series+ front-panel control
  • 220i-Series+ front-panel control
  • 250i-Series+ front-panel control
  • 303i-Series+ front-panel control
  • 310i-Series+ front-panel control
  • 353i-Series+ front-panel control
  • 363i-Series+ front-panel control
  • 371i-Series+ front-panel control
  • 380i-Series+ front-panel control
  • 393i-Series+ front-panel control
  • 400i-Series+ front-panel control
  • 430i-Series+ front-panel control
  • 443i-Series+ front-panel control
  • 520i-Series+ front-panel control
  • 540i-Series+ front-panel control
  • 610i-Series+ front-panel control
  • 700i-Series+ front-panel control
  • 710i-Series+ front-panel control
  • 720i-Series+ front-panel control
  • 763i-Series+ front-panel control
  • 831i-Series+ front-panel control
  • 890i-Series+ front-panel control
  • FFFi-Series+ front-panel control
  • SSi-Series+ front-panel control
  • SEi-Series+ front-panel control
  • 100i-Series+ front-panel control
  • 120i-Series+ front-panel control
  • 140i-Series+ front-panel control
  • 150i-Series+ front-panel control
  • 170i-Series+ front-panel control
  • 190i-Series+ front-panel control
  • 250i-Series+ front-panel control
  • 303i-Series+ front-panel control
  • 310i-Series+ front-panel control
  • 353i-Series+ front-panel control
  • 363i-Series+ front-panel control
  • 371i-Series+ front-panel control
  • 380i-Series+ front-panel control
  • 393i-Series+ front-panel control
  • 400i-Series+ front-panel control
  • 430i-Series+ front-panel control
  • 443i-Series+ front-panel control
  • 520i-Series+ front-panel control
  • 540i-Series+ front-panel control
  • 700i-Series+ front-panel control
  • 720i-Series+ front-panel control
  • 763i-Series+ front-panel control
  • 831i-Series+ front-panel control
  • 890i-Series+ front-panel control
  • 55i-Series+ front-panel control

Manuals

Official documents

Where ROMA provides on-site service

On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.

See all service areas

Frequently asked questions

Can an I-Series+ solo boiler make domestic hot water?

No. A solo is heating-only: domestic hot water is produced by an indirect tank or another appliance. The boiler controls indirect-tank recovery — tank priority is the default and parameter 33 permits simultaneous tank and central-heating operation.

What is the difference between the solo and the combi models?

The combis (codes ending in C) make hot water on demand inside the boiler, while the solos (codes ending in S) have no DHW connections at all. A solo suits homes that keep a separate indirect tank; a combi suits homes that want tankless-style hot water from the boiler itself.

Why are IP175S and IP199S draft models on this site?

Both are current Canadian products, but their English I&O manual is a raster-only scan, so Boilers.ca has not published final spec figures for them pending review. They are also the two solo models named in Health Canada recall RA-77507.

Talk to a boiler technician

Describe what the boiler is doing and get a straight answer about the next step.

On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.

Sources and verification

Facts checked September 7, 2026. Last updated September 7, 2026. Technical reviewer: not yet assigned.

CallEmailEstimate