Lochinvar Crest Gas Valve / Relay Failure — Main Control Board Did not Detect a Gas Valve
Gas Valve / Relay Failure
Main control board did not detect a gas valve. The main control board did not detect a gas valve, so check the wiring harness connection at the gas valve and at the main control board, replace the wire harness, the gas valve, or the control board. The table classifies it as Lockout (manual reset).
If you smell gas
- Stop what you are doing. Do not use phones, switches, matches or anything that can spark inside.
- Go outside and leave the door open behind you.
- Call the FortisBC 24-hour emergency line at 1-800-663-9911 or dial 911.
Only after that, call ROMA about the boiler. Official guidance: FortisBC gas leaks and odour.
Applies to
This gas-train fault code is displayed by the Crest control (text faults) on Crest with Hellcat models (FCB1000 through FCB6000), as documented in Crest with Hellcat (FCB) Service Manual, 100343237 Rev D — Table 3G fault codes (100343237 Rev D). Codes can differ between controller generations, so always check the manual that matches your unit.
- Lochinvar Crest (FB / Hellcat FCB)
- Lochinvar Crest FBN0751
- Lochinvar Crest FBN1001
- Lochinvar Crest FBN1251
- Lochinvar Crest FBN1501
- Lochinvar Crest FBN1751
- Lochinvar Crest FBN2001
- Lochinvar Crest FBN2501
- Lochinvar Crest FBN3001
- Lochinvar Crest FBN3501
- Lochinvar Crest FBN4001
- Lochinvar Crest FBN5001
- Lochinvar Crest FBN6001
- Lochinvar Crest FCB1000
- Lochinvar Crest FCB1500
- Lochinvar Crest FCB2000
- Lochinvar Crest FCB2500
- Lochinvar Crest FCB3000
- Lochinvar Crest FCB4000
- Lochinvar Crest FCB5000
- Lochinvar Crest FCB6000
Controller: Crest control (text faults). Source manual: 100343237 Rev D (2025-07).
Why a code is not a diagnosis
A gas-train code involves the gas valve or its electrical circuit. It does not mean there is a leak; the circuit, coils and wiring must be measured by a licensed technician.
Safe things to observe
- If you smell gas, stop, go outside and call your gas utility's emergency line or 911 before anything else.
- Note the exact code and what the appliance was doing when it appeared.
- Check whether other gas appliances in the building are working.
Do not
- Do not reset or run the appliance while the gas valve circuit is suspect.
- Do not touch the gas valve.
How professional service helps
- A technician verifies harness connections and coil resistances against the manual before replacing parts.
- Combustion and safety devices are verified with an analyser and the manufacturer's procedure after any repair.
Where ROMA provides on-site service
On-site service is currently offered in Greater Vancouver, BC, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Port Coquitlam, Port Moody, Delta, Langley, Maple Ridge, Abbotsford, Chilliwack, White Rock, Pitt Meadows, Tsawwassen, Anmore, Lions Bay, Belcarra, Bowen Island, Mission. Everything else on this site is reference information you can use anywhere in Canada.
Parts and service
Parts commonly involved
These parts appear in the documented text for this alert. A code reports a condition, not a failed part — a technician confirms the cause by testing before anything is replaced.
Gas valve
The gas valve is the boiler's controlled gateway for gas: it opens only when the control has proven safe conditions, meters the fuel to the burner,…
What a technician checks →Control board / PCB
The control board — also called the PCB, or printed circuit board — is the boiler's main computer.
What a technician checks →
Service for this alert
- Gas Boiler Repair
Licensed gas technicians from ROMA Heating & Cooling diagnose and repair residential and light-commercial gas boilers across…
- Emergency Boiler Repair
Priority gas boiler repair for homes and buildings in Greater Vancouver with no heat, no hot water, a locked-out boiler or a leak.
Every boiler part explained — what it does, how it fails and what a technician checks.
Documented for Lochinvar Crest (FB / Hellcat FCB).
Frequently asked questions
Does this code mean I have a gas leak?
Not by itself. If you smell gas, stop, leave the building and call your gas utility's emergency line or 911 from outside before anything else. Otherwise the code points to a fault a technician confirms on site.
Can I clear this code myself?
Clearing a code without fixing its cause usually just brings it back. Note the code, check the safe items on this page, then call a licensed technician. If your appliance manual describes a user reset for this exact code and it stays away, no call may be needed.
Boiler locked out? Call with the alert text ready.
The brand, model and this alert are passed along when you request service online, so the technician arrives prepared.
On-site service in Greater Vancouver, BC. ROMA lists “Open 7 days” on its site; call to confirm same-day availability.
Sources and verification
- Crest with Hellcat (FCB) Service Manual, 100343237 Rev D — Table 3G fault codes · 100343237 Rev D · accessed September 7, 2026
Facts checked September 7, 2026. Last updated September 7, 2026. Technical reviewer: not yet assigned.